When a Tacoma chimney smells damp, stains the ceiling, or smokes on a wet night, the weather is usually part of the story. Our techs check the cap, crown, flashing and flue as one system, repair what the rain reached, and leave it ready to burn.
Your information is kept private and used only for your chimney service request.
Sweep, cleaning, repair, leak repair, cap repair and liner repair - the full chimney service list for Tacoma, with the same crew and the same free estimates. Below is chimney in Tacoma, WA in full — every service, the local conditions and the areas covered.
Sweep & Cleaning
Chimney Sweep
The full professional sweep: rotary brushes scrub the flue from top to bottom while a HEPA vacuum keeps every speck of soot sealed in — the visit that keeps a chimney safe to burn in. In Tacoma, that includes clearing storm debris and needles the wet season dropped in. The crews behind chimney sweep in Tacoma, WA are the same ones who cover the ZIP codes listed below.
Get a free estimate
Sweep & Cleaning
Chimney Cleaning
In Tacoma, damp wood fires lay down wet creosote that clings to the flue walls. Creosote, soot and ash removed from the flue, smoke shelf and firebox — the deep clean that kills the campfire smell and the fire risk with it. For chimney cleaning in Tacoma, WA, one call books the visit and a local tech takes it from there.
Get a free estimate
Repair
Chimney Repair
Any chimney, any problem — leaks, cracks, crumbling brick, bad draw. A crown that ponds water instead of shedding it gets rebuilt to drain properly. Diagnosed on camera first, then repaired properly with the right materials. That local standard is what chimney repair in Tacoma, WA means with Chimney Service Co.
Get a free estimate
Inspection & Care
Chimney Inspection
A full inspection of flue, liner, cap, crown, flashing and firebox — camera inside the flue, with a plain-language report of what is safe, what is not, and what can wait. Around Tacoma, the report names where water is entering as well as what it has damaged, so the repair fixes the entry point, not only the stain. Booking chimney inspection in Tacoma, WA takes one call, and the tech arrives with everything the job needs.
Get a free estimate
Install & Replace
Chimney Cap Installation
A quality stainless cap keeps rain, birds and sparks where they belong. Fitted to your flue, secured properly, and screened against animals. The screen keeps evergreen needles, cones and nesting birds out, so storm debris stops collecting on the smoke shelf between fires. That is chimney cap installation in Tacoma, WA, done the way it should be.
Get a free estimate
Repair
Chimney Liner Repair
Cracked tiles, gaps at the joints, a liner that is shifting — liner faults found on camera and repaired so hot gases stay inside the Tacoma flue where they belong. Around Pierce County, older liners often show water staining long before they fail. When neighbors talk about chimney liner repair in Tacoma, WA, this is the visit they mean.
Get a free estimateNeed something else — a damper, a blower, a smoke problem, a bird in the flue? We cover all 27 fireplace specialties. Call (888) 258-0797 and describe it.
A chimney in Tacoma is not fighting cold so much as water - months of rain, wind-driven storms and masonry that rarely gets a chance to dry out. This is what we actually find here, and what we check on every visit.
Months of steady rain test every joint, crack and seam a chimney has in Tacoma. Water enters at a cracked crown, tired flashing or porous mortar, then travels down inside the masonry. By the time a stain shows by the fireplace, the chimney has usually been wet for a long while.
Brick and mortar that stay wet for months start to break down: mortar softens, brick faces flake, and the chimney weakens from the outside in. Saturated masonry in Pierce County also holds water against the flue, which rusts dampers and stains fireboxes. Catching it early keeps a repair small.
Winter storms drop limbs, needles and cones into open flues across Tacoma, and a blocked flue pushes smoke and carbon monoxide back into the room. Evergreen debris also holds moisture against the flue walls. A sound, screened cap keeps the flue clear through storm season without hurting the draw.
When a hard freeze follows weeks of rain, water trapped in saturated masonry expands as it turns to ice, cracking mortar and splitting brick faces. Northwest chimneys get fewer freezes than mountain ones, but the ones they get land on wet masonry. Post-freeze cracking is a repair we watch for here.
Tacoma sits in Pierce County, and the ZIP list at the bottom of this page covers 24 serviceable ZIP codes — 98402 through 98499. The closest served neighbors are Fircrest, Lakewood, University Place, and every one of them is covered by the same crews, the same day, under the same number: (888) 258-0797.
Same-day service, free estimates, licensed & insured — and a flue you can see on camera, clean from top to bottom.
Wind-driven rain gets pushed into caps, joints and flashing that shed a gentle shower easily, so the leak appears only in storms. The entry point is usually at the top - a cracked crown, lifted flashing or rusted cap. We trace the leak from the top down and repair the actual source, so the fix holds in storm weather.
Usually moss or algae, and it matters more than it looks. Growth holds moisture against the brick and works into softened mortar joints, keeping the masonry wet and speeding its breakdown. Removing growth without fixing the damp underneath does not last. We check the masonry under the growth and tell you what condition it is really in.
A wet, cold flue draws poorly until it warms, and water in the chimney makes that worse. The cause can also be a partial blockage from storm debris or creosote swollen with moisture. A tech checks the flue, cap and liner on camera in Tacoma and fixes the cause, rather than treating every smoky startup as normal Northwest weather.
At least once a year if you burn regularly, and after roughly every cord of wood. Damp wood and cool, smoky fires - both common here - lay down wet, tarry creosote faster than dry wood and hot fires do. That buildup is both a fire risk and the source of the sour smell a wet flue carries all summer.
Very likely. Water entering the chimney soaks soot and creosote, and damp deposits smell musty and sour, stronger in warm weather. The smell is a symptom; the cause is an entry point at the cap, crown or flashing, or saturated masonry wicking moisture in. We find where the water enters and fix that, then clean the flue.
No — and be wary of anyone who does. Every chimney fails differently, so a phone price is a guess that changes at your door. Our estimates are free: a tech looks at the actual problem, then gives you one clear price before any work starts.
Chimney Service Co is a national company with local technicians serving Tacoma street addresses across the ZIP codes below — same-day service and free estimates, every day 8 AM – 8 PM. More of Washington is covered from our Washington page. The Tacoma list below covers 24 ZIP codes, 98402 through 98499.
Don't see your ZIP? Tacoma also uses P.O. Box and single-organization ZIP codes that have no street addresses — call (888) 258-0797 and we will confirm coverage for your street address on the call.
Also serving nearby: Fircrest, WA · Lakewood, WA · University Place, WA · Fife, WA · Ruston, WA · Steilacoom, WA.
Message sent.
Thanks — we'll get back to you shortly. Need it faster?
